Euro S50 TB´s

**Jan(denmark)** · 02-06-2003,07:43 AM

Anyone know the size of the euro S50 TB´s?? And if it is possible to fit them on the S14??

**M3NTAL Kev** · 02-07-2003,09:00 PM

Originally posted by Jan(denmark)
Anyone know the size of the euro S50 TB´s?? And if it is possible to fit them on the S14??

Hmmm... not sure... but I think someone mentioned that the S38 TBs would work... I think they're 50mm too... however I could be mistaken...

**MPOWER619** · 02-07-2003,11:04 PM

I know of some one making plates to fit custom 52mm Throttle bodies. I dont recall who it was it is either PAUTER MACHINE or APEX MOTORSPORTS.

**///M-fart** · 02-08-2003,09:24 AM

They fit only without gasket !

**mrsha007** · 02-09-2003,02:36 AM

Originally posted by ///M-fart
They fit only without gasket !

so the s38's fit without a gasket? no leaks?

**///M-fart** · 02-09-2003,06:34 AM

clean flat surfaces are condition.
There is no ruber Gasket, only some paper.

Dan

**///M-fart** · 02-09-2003,10:54 AM

SORRY, I AM WRONG:

I was talking about S38 bodies, not S50 !!

Dan

**mrsha007** · 02-09-2003,05:24 PM

Originally posted by ///M-fart
SORRY, I AM WRONG:

I was talking about S38 bodies, not S50 !!

Dan

thats what im asking. so i can just put on s38 TB's and horns with just the paper gasket? can anyone else back this up? ever seen it done?

**Reelizmpro** · 02-09-2003,06:44 PM

Aren't the S38 TB's 2 banks of 3? while ours are 2 banks of 2. I'm having a hard time seeing them work unless the S38 TB's are 3 banks of 2. That's something to look into though.

**m3geezer** · 02-12-2003,05:05 PM

what i'm looking at doing is to get my euro 48mm throttle bodies bored out to 50mm and then fit 50mm butterflies in, i know people that have done this to the 46mm upto 48mm, apparently you can't go any bigger than 48 with the 46mm's.

i think 50mm must be plenty big enough for the s14, bare in mind you have to then port the intakes to the same size which is a fair bit of work.

**AlexMc** · 02-13-2003,10:22 AM

The Euro S50 has 45mm throttle plates.

The BMP/Bekkers US 6-fly setups were running 50mm plates and this combined with their supershort trumpets made for basically no power increase with a shitload of torque loss, all for $3495.95!

**mrsha007** · 02-13-2003,04:36 PM

Originally posted by Reelizmpro
Aren't the S38 TB's 2 banks of 3? while ours are 2 banks of 2. I'm having a hard time seeing them work unless the S38 TB's are 3 banks of 2. That's something to look into though.

barry, i think they are 3 sets of two, because they have three TB arms.

Thread: Euro S50 TB´s

Thread Tools

Display